106
Cleaning Stainless Steel Surfaces
– Only use conventional household cleaning agents which are suitable for stainless steel.
– Only use solvents for cleaning stainless steel parts.
t All stainless steel parts should be cleaned at regular intervals: Rub stainless steel surfaces
with a moist cloth, with a cleaning agent if required, then remove all residue from the
surface.
t Allow device to dry. For additional protection, protective oil may be applied.
Replacing the Dust Cover
A damaged dust cover should be replaced immediately.
t Remove damaged dust cover.
t Place the new dust cover on the display and control unit and press it over the edge of the
front and rear side of the device until it is fixed in place.
Safety Inspection
Safe operation of the equipment is no longer ensured:
– The device or the mains connecting lead shows visible damage.
– The integrated power supply for the indicator no longer functions properly.
– The device has been stored for a relatively long period under unfavorable conditions
(e. g., excessive humidity)
If there is any indication that safe operation of the device is no longer warranted:
t Disconnect the power supply to the device (unplug the power cord from the mains supply)
and make sure the device cannot be used for the time being.
t Notify your nearest Sartorius Service Center.
Maintenance and repair work may only be carried out by service technicians:
– Who have access to the required maintenance documents and manuals
and
– Who have attended the appropriate training workshops
h
The seals on the device indicate that the device may only be opened and maintained by
authorized specialist personnel, so that the correct and safe operation of the device is
ensured and the guarantee remains valid.
Care and Maintenance
To Next Page
Loading...
Need help?
General
