17
Configuring Weighing Platforms
Service Mode
Purpose
The Service mode enables access to additional menu items in the Setup menu which are
not displayed when the Service mode is not active. The most important calibration and
adjustment work for the indicator and for the connected weighing platform can be
carried out in the Service menu, e.g. ADC configuration.
When the Service mode is active, an “S” is shown in the top right-hand corner of the
display. To deactivate the Service mode, restart the indicator (turn the indicator off and
back on again).
Activating the Service Mode
t Press e to turn on the device.
y When turned on the scale is in an application program.
t Enter the service password (see Appendix General User Password) and press M to
confirm.
y The device in now is Service mode. An “S" appears in the top right-hand corner of the
display.
t Press the “q" soft key several times to select the “Device parameters" line.
t Press the “O" soft key.
y The “Device" submenu will open.
t Select and open the corresponding submenu. Repeat this procedure until the desired
menu item in the lowest menu level can be opened.
t View or change the menu item (confirm with “l") and use “o" to return to the previous
menu.
t Press M or “oo" to exit the Setup menu.
Exiting Service Mode
Turn the device off and then on again to return to the normal application mode. If you
exit the Setup menu without changing settings by confirming with M or the “
oo"
soft key, the Service mode will remain active. Press the M key to re-open the Setup
menu.
To Next Page
Loading...
Need help?
General
