t Use the “O" soft key to open the CAL key function" menu.
y The “CAL key function" submenu is displayed.
t Use the “Q" or “q" soft key to select the corresponding menu item and confirm with
“
l."
y The menu item is marked by a circle “o."
Note
The functions that can be configured in the “
CAL key function" submenu
depends on the selected weighing platform and its configuration data. Functions that
cannot be accessed are not displayed in the selection screen.
Important Note!
The function set in the “
CAL key function" menu is carried out in the
normal weighing mode because when you exit the Setup menu the Service mode is
deactivated. To perform the function on a digital weighing platform (such as an
IS platform), however, it must be carried out in Service mode.
t The procedure is as follows: after selecting the desired function and exiting the Setup
menu, reactivate Service mode again and then exit the Setup menu immediately by
pressing the M key or the “
oo" soft key.
y The scale is now in Service mode without this being displayed.
t Trigger the previously set function using the J key.
y The display shows “S_CAl:" indicating that the scale is in Service mode.
t The corresponding menu item can be selected using the “Select" soft key and
carried out using the J key.
t If you cancel the function using the ( key or by restarting the scale using the e key,
you will exit the Service mode.
External Calibration/Adjustment with Factory-Defined Weight
(Default Weight)
Configuration
If not already selected (factory setting, marked by “
o" when active), select the “CAL
key function:Ext. cal./adj.; factory-def. wt.
"
menu item (external adjustment with a factory-defined, standard weight).
t Use the “Q" or “q" soft key to select this menu item and confirm with “l."
y The menu item is marked by a circle “o."
Note:
The menu items “
Ext. cal./adj.; factory-def. wt." (external
adjustment with a factory-defined, standard weight), “
Ext. cal./adj.;
user-defined wt." (external adjustment with a user-defined weight) and
“
Key blocked" can also be accessed without activating the Service mode.
t Press e to turn off the device.
t Press e turn the device back on.
y The Sartorius logo is displayed briefly, after which the device is in normal weighing
mode.
t Press ( to unload and zero the scale.
t Press J to start the external adjustment.
y The display “C.EXT.D" appears briefly.
Note
If the display of geographical data (elevation and latitude or gravity) is activated, this
data is displayed and confirmed each with a press of the J key (you can cancel the
calibration/adjustment process using the ( key). See also “Entering Geographical
Data for Use in Legal Metrology" in this chapter.
34
Configuring Weighing Platforms
C.EXT.DEF.
To Next Page
Loading...
Need help?
General
