Configuration
You can configure the indicator by selecting parameters in the Setup menu. These are
divided into the following groups (menu level 1), menu structure see section the “Setup
Overview (Parameters)" section
–
Application parameters
– Fn key function
– Device parameters
– Info (device-specific information)
–
Language
When used in legal metrology, not all parameters can be accessed. The indicator only
displays parameters that can be selected.
Factory-set parameters are identified by an “o” in the list starting on the next page.
Setting the Language
You can choose from the following languages for displaying information:
–
Deutsch
– English (factory setting)
–
U.S. mode
– Français
– Italiano
– Español
Example: Selecting “U.S. Mode" for the language
t Press e to turn on the device.
t Press M.
y The menu appears on the display.
t Press the “q" soft key several times to select the “Language" line.
t Press the “O" soft key.
y The language selection appears on the display.
t Press the “Q" soft key to select the “U.S. mode" line.
t Press the l soft key to save the setting.
y The setting selection “o" moves to “U.S. mode."
t Press M or oo to exit the Setup menu.
Operating Design
52
To Next Page
Loading...
Need help?
General
