Operation
Data ID Codes
You can assign codes (such as product name, batch number, etc.) for identification of
measured values in all application programs.
Features
– Assign up to six ID codes.
– Assign both a name and a value to each ID code.
– Displaying individual IDs: press the “
ID" soft key.
– The name is left-justified and the value is right-justified on the printout. If the entire
code is too long for one line, additional lines are printed.
– Enter ID code names in Setup under: “
Device parameters:Config.
printout:ID codes."
– The name can have a max. of 20 characters. When entering the
ID value, no more than
11 characters are displayed during input; however, all 20 characters are printed.
– Enter up to 21 characters for the value of the ID code. Press the “
ID" soft key to
activate the input mode.
– Enter the first ID value directly through the numeric keypad. Press the “
1st ID" soft
key to save the value.
– Individual characters of the ID can be deleted using the ( key. Complete ID code
values can be deleted using the “
Delete" soft key.
– If both the name and value fields are empty, no ID code is printed.
– In the Setup menu, you can configure when and whether ID codes are printed (see
included “Application Programs" instructions, “Configuring Printouts").
Settings for individual ID codes
Setup menu: “
Device parameters:Config. printout:
ID codes"
Factory settings for ID code names:
ID1: “
ID1"
ID2: “
ID2"
ID3: “
ID3"
ID4: “
ID4"
ID5: “
ID5"
ID6: “
ID6"
There are no factory settings for ID code values.
86
To Next Page
Loading...
