Commissioning PR 5211 Instrument Manual
EN-26 Sartorius
4.2 Switching on the Instrument
All setup and configuration will be done with the program 'ConfigureIt! 6.00 (or higher) Setup.exe'.
Via the ProfiBus interface an additional access to each parameter is possible.
4.3 Installation of USB Chip Drivers
• If necessary download the USB chip driver from the internet.
• Open the internet browser.
Note: The internet address may have changed (In this case contact Sartorius.).
• Enter ‚www.ftdichip.com/Drivers/VCP.htm
‘ and confirm.
The web page is displayed.
• Select and click the link of the appropriate operating system in the table (e.g. ‚2.08.28‘).
A ZIP folder is downloaded.
• In the menu of the opened ZIP folder select: [Order]-[Unpack in selected file…], then choose target file
and click OK.
• Click the link ‚Installation Guides‘ to open the installation instructions.
• Install the driver as described in the installation instructions.
To Next Page
Loading...
