Sartorius PR 5211 Series - Load and Store Setup and Configuration; Data in the PR 5211; Archive Data in the PC; Print Data Set

Commissioning PR 5211 Instrument Manual
EN-28 Sartorius
4.5 Load and Store Setup and Configuration
4.5.1 Data in the PR 5211
The current data can be loaded from the PR 5211 to the ConfigureIt!, edited and save back to the PR 5211.
In the menu 'ADU' and 'Parameter' the data sets can
be loaded and stored.
Each time all data are loaded or stored.
If the data are changed, the program asks when a page is changed or the program will be quit, if the
changes should be stored or not.
If an access code is set, it will be asked now.
4.5.2 Archive Data in the PC
The actual data set in the ConfigureIt! can be stored as a file on the PC and reloaded again. So, all
configuration data can be archived on the PC.
Load from File
Load the default values (factory delivery)
contained in the file DEFAULT.DAT for
ConfigureIt!. The default dataset cannot be
overwritten. If a new configuration has to
be stored, change the name.
Save to File
Store the modified data under a name
different to DEFAULT.DAT
4.6 Print Data Set
Print Dataset
The current calibration data and all
parameters are printed on the printer
assigned as standard printer, see example
in chapter 12.5.