SATO CL4NX - [Sensor Type]; [Auto-Mode]

225
[Sensor Type]
Set the sensor type for detecting the media.
The options are as follows:
None
Disable the media sensor.
Gap
Select when using the media of Gap type. Use the transmissive type sensor.
I-Mark
Select when using the media of I-mark type. Use the reflective type sensor.
• If you have selected [Tear-Off], [Dispenser], or [Cut & Print] in the [Print Mode] menu,
only [Gap] and [I-Mark] will be available.
• If you have selected [Linerless] in the [Print Mode] menu (CL4NX only), only [None]
and [I-Mark] will be available.
[Auto-mode]