SATO CL4NX - Page 479

479
• This function cannot be used in the following conditions:
◦ When the print mode is tear-off mode
◦ When you are using CL4NX RFID models
◦ When the printer is in AEP mode
• Use the optional barcode checker stand kit to mount the barcode checker to the printer.
For details, refer to the Barcode Checker Stand Kit Installation Manual that came with
the barcode checker stand kit.
[Test]
Set up the barcode checker.
Available only if you have connected the barcode checker.
The setting items are as follows:
Reader Name
Shows the barcode checker connected to the printer.
Reading Test
Perform a test read with the connected barcode checker.