521
(8) Frame
• For the CL4NX RFID model, the position of the I-mark sensor becomes a minimum
of 0.3 mm (0.01") when the position of the gap sensor is adjusted to around 7.3 mm
(0.3"). Because of this, the paper end may be frequently detected when the [Advanced]
> [Paper End] of the [Printing] menu is set to [Using I-mark] (the default), due to the
shifting of the media or other causes. When you have adjusted the position of the Gap
sensor to around 7.3 mm (0.3"), change [Paper End] to [Using Gap].
To Next Page
Loading...
