SATO CL4NX User Manual

645
Print modes Ranges to be avoided
Cutting according to the specified number of labels
Approximately 44 mm (1.73") from the print end position
Cut & Print Approximately 44 mm (1.73") from the print end position
Dispenser No restriction
Linerless (CL4NX only) Approximately 25 mm (0.98") from the print end position
• The barcode check is not performed if the position at which the check starts is detected after the
label feeding begins to stop. Define the label layout and position at which the check starts by
keeping in mind that the distance required for stopping is proportional to the print speed.
• Printed barcodes or 2D codes can be read only with a size at which their entire pattern is within
the scanning range of the barcode checker. A reading error may occur depending on the print
position.
• This function cannot be controlled through the use of external signals (EXT).
Restrictions When Using GFS4470
• By the double-reading prevention function, the barcode checker may not read barcodes that are
printed successively if they are within the readable area. Adjust the print position so that same
barcodes are not within the readable area.
• When printing composite symbols that use GS1 DataBar, the read data and print data never
match if the barcode data is 16 digits or less. A comparison error occurs in comparison mode.
• Though "\" (0x5C) specified in MAXI code, print data should be read as "\\" in the specifications.
However, it may not be read as such, depending on the following data. For example, "\A"
specified in print data should be read as "\\A" in the specifications, but it is actually read as only
"A".
Restrictions When Using WB1F-100S1S
• Multiple barcodes cannot be read at the same time.
• When NUL (0x00) is included in CODE128 print data, only the data before NUL is recognized
as reading data, and NUL and the data after NUL are ignored. A comparison error occurs in
comparison mode. In readable mode, a reading error occurs only if NUL is specified at the
beginning of the print data.

SATO CL4NX Specifications

General

Wi-Fi	No
Ethernet LAN	Yes
Flash memory	2000 MB
Storage media	Flash
Internal memory	256 MB
Built-in barcodes	Code 39, Code 93, Code-128 Codabar Library, EAN13, EAN8, GS1 DataBar, Industrial 2/5, Interleaved 2/5, Matrix 2/5
Internal storage capacity	2 GB
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	30 - 90 %
Operating relative humidity (H-H)	30 - 80 %
Maximum roll diameter	220 mm
Maximum printing width	104 mm
Printing media thickness	0.06 - 0.26 µm
Display type	LCD
Product color	Black
Display diagonal	3.5 \
Display resolution	320 x 240 pixels
AC input voltage	100 - 240 V
Power source type	AC
AC input frequency	50 - 60 Hz
USB connector	USB Type-A / USB Type-B
Bluetooth version	3.0
Serial interface type	RS-232C
USB 2.0 ports quantity	2
Connectivity technology	Wired & Wireless
Type	POS printer
Print speed	10 ips
Print technology	Direct thermal / Thermal transfer
Maximum resolution	203 x 203 DPI

Weight and Dimensions

Depth	457 mm
Width	271 mm
Height	321 mm
Weight	15000 g