702
Error Message 1004 (Overrun Error)
When there is an error with the printer, the error message appears on the screen.
Check the cause and countermeasure, and then take appropriate action.
To clear the error:
Press the button (OFFLINE) or button, or adjust the settings.
Cause and Countermeasure
Cause (1)
RS-232C settings are incorrect.
Countermeasure (1)
Set the interface settings of the printer again.
RS-232C
Cause (2)
The RS-232C cable is not connected correctly.
Countermeasure (2)
Power off the printer, connect the RS-232C cable correctly, and then power on the printer again.
Powering On/Off the Printer
RS-232C Interface Connection (Standard)
Contact your SATO technical support center if the error cannot be resolved.
Contact Information for When You Are in Trouble
To Next Page
Loading...
