SATO CL608 - Page 103

PN 9001024
Rev. B Jan. 2000
Page 6-6
SATO CL608 & CL612 SERVICE MANUAL
SECTION 6 – Replacement Procedures
6-3 Replacing Fuses
6-3.2 Removing and Replacing the 1A, 250V or 3.15A, 250V Fuse(s)
Required: 1A, 250V Fuse or 3.15A, 250V Fuse
To remove and replace these fuse(s) do the following:
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cable.
2. Remove (3) screws holding the left side cover to the printer. Raise the
access door and loosen the (2) screws on the inside top of the printer.
Lift off the left side cover to expose the main PCB. Refer to Section 4-2,
Fig. 4-1 & 4-2.
3. Refer to Fig. 6-7 and locate the appropriate fuse on the PCB.
4. Remove and replace the fuse(s) with one of equal rating. Do not use a
fuse with a higher rating.
5. Replace the cover and replace the screws.
6. Return the printer to service by reconnecting the power cable.
Fig. 6-7
MAIN PC BOARD
FUSES