SATO CL608 - Advanced Mode Settings and Adjustments

PN 9001024
Rev. B Jan. 2000
SECTION 2 – Configuration
Page 2-14
SATO CL608 & CL612 SERVICE MANUAL
If the printer has a print job(s) loaded in memory, selecting YES will cause the
job(s) to be cleared. The default selection is NO. Make sure that you want to
cancel the print job before selecting YES as the job cannot be recovered and will
have to be retransmitted to the printer.
To cancel the print, perform the following steps:
STEP PROCEDURE
1. Use the LINE key to step the underlined cursor to either
YES or NO.
2. Once the correct setting is underlined, press the FEED key to accept
the setting and terminate the user mode of operation and return to
the normal mode OFFLINE display.
If you wish to change any of the settings, you must enter the user
mode again by simultaneously pressing FEED and LINE keys for
more than one second.
2-4 Advanced Mode Settings and Adjustments
Advanced mode is provided to make adjustments that require only occasional
adjustments. Since they affect the basic operation of the printer, the procedure for
entering this mode is designed to prevent someone from accidentally changing the
settings.
To enter advanced mode, the printer is powered on while pressing the LINE key.
The printer will emit an audible signal and display Advanced Mode Setup on the
LCD panel.
From the advanced mode display, the advanced settings are accessed in sequence
by pressing the FEED key.
Cancel Print Job
cancel print job
no yes
advanced mode
setup