PN 9001024
Rev. B Jan. 2000
Page 9-6
SECTION 9 – Addendum
SATO CL608 & CL612 SERVICE MANUAL
Serial No. 81199999 and below
Fuse replacement is described in the following section.
•
9-3.1 Removing and Replacing the Main Power Fuse
•
9-3.2 Removing and Replacing the 1A, 250V Fuse
•
9-3.2 Removing and Replacing the 3.15A, 250V Fuse
9-3.1 Removing and Replacing the Main Power Fuse
NOTE: Before replacing a fuse, determine
the cause of the overload condition.
Required: 15A, 250V Fuse
9-4 Replacing the Fuses
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cable.
2. Locate the fuse cap on the back of the printer. Unscrew the cap and
remove the defective fuse.
3. Replace the fuse with one of equal rating (15A, 250V). Do not use
a fuse with a higher rating. Fig. 9-2
4. Screw the fuse cap back and reconnect the power cable.
BACK OF PRINTER
FUSE (UNDER
FUSE CAP)
Fig. 9-2
CL608 & CL612
Serial #8199999 and below
To Next Page
Loading...
