PN 9001024
Rev. B Jan. 2000
Page 9-8
SECTION 9 – Addendum
SATO CL608 & CL612 SERVICE MANUAL
Serial No. 81199999 and below
9-5 Replacing the Power Supply
STEP PROCEDURE
1. Refer to Section 9-3 and detach the main circuit board for access to the
power supply.
2. Lower the media holder in the mechanical section of the printer for
access to (2) screws securing the power supply. Remove the screws.
Figs. 9-4 & 9-5
3. Remove (2) screws from the back end of the printer which fastens the
power supply to the wall. Fig.9-6
4. Detach (2) cable connections and remove the defective power supply.
5. Install a replacement power supply using screws previously removed.
6. Reattach the cable connections.
7. Reinstall the main circuit board.
8. Replace the left side cover and reconnect the power cable.
9. Check the DC power voltages. Refer to Section 9-10.
Fig. 9-4
LOWER THE
MEDIA HOLDER
CL608 & CL612
Serial #8199999 and below
To Next Page
Loading...
