SATO CL608 - Centronics Parallel Interface Details

PN 9001024
Rev. B Jan. 2000
Page 3-13
SATO CL608 & CL612 SERVICE MANUAL
SECTION 3 – Interface Specifications
3-6 Centronics Parallel Interface
rotcennoCretnirP
tnelaviuqero)KDD(06304-75PMA
rotcennoCelbaC
tnelaviuqero)KDD(06303-75PMA
htgneLelbaC
sselro.tf01
leveLlangiS
V0.5+otV4.2+=hgiH
V4.0-otV0=woL
Single Job Buffer: The Single Job Buffer mode is not available when using the Centronics
interface
Multi Job Buffer: <STX><ESC>A..Job#1..<ESC>Z<ETX>
<STX><ESC>A..Job#n..<ESC>Z<ETX>
Note that for parallel communications, the 56: and -6: characters are not required.
Data Streams
3-5 Dip Switch Settings for RS232 Serial Interface
DSW1-5 DSW1-6 SETTING
Off Off 9600
Off On 19200
On Off 4800
On On 2400
Baud Rate Selection (DSW1-5 and DSW1-6): Selects the data rate (bps) for
the RS232 port.
DSW1
ON
OFF
1 2 3 4
5 6 7 8
DSW1-7 DSW1-8 SETTING
Off Off Rdy/Bsy
Off On Xon/Xoff
On Off Bi-Com
On On Status 2
Protocol Selection (DSW1-7 and DSW1-8): Selects the flow control and status
reporting protocols. See Section 5: Interface Specifications for more information.
DSW1
ON
OFF
1 2 3 4
5 6 7 8