PN 9001024
Rev. B Jan. 2000
Page 7-2
SATO CL608 & CL612 SERVICE MANUAL
SECTION 7 – Factory Resets
7-2 Factory Test Print Without Resetting Printer
STEP PROCEDURE
1. Record all current dip switch positions, then place all switches in the
OFF or down position.
2. Place the DSW2-5 in the ON or up position.
3. Place the print head in the open position. Keeping both the LINE and
FEED keys depressed, power on the printer.
4. Upon hearing the audible tone, release the LINE & FEED keys. Place
the print head back in the closed position and DSW2-5 in the OFF or
down position.
5. Verify display: "FACTORY MODE".
6. Press the FEED key once. Verify display: "COUNTER CLEAR NON".
7. Press FEED button to initialize test print without resetting printer.
After a slight pause, (1) blank label will feed out followed by a factory
test print.
Warning: This test activates all the heating elements
on the print head and therefore should be used for
testing purposes only with full width labels to avoid
damaging the print head.
8. Press the FEED key to stop printing.
9. Place the printers power switch to the OFF position and return all
switches to their original positions.
FACTORY MODE
COUNTER cLEAR
NON
To Next Page
Loading...
