PN 9001024
Rev. B Jan. 2000
Page 9-1
SATO CL608 & CL612 SERVICE MANUAL
Serial No. 81199999 and below
Addendum
9-1 Overview
Some procedures for units with serial numbers 81199999 or below are different than
those shown in the preceding sections. The procedures that are different are covered
in this addendum. A summary of the differences are shown in Section 9-2.
9
Section
Sub-sections in this addendum include the following:
•
Section 9-2 Notable Differences
•
Section 9-3 Replacing the Main PCB
•
Section 9-4 Replacing the Fuses
•
Section 9-5 Replacing the Power Supply
•
Section 9-6 Installing the Memory Board
•
Section 9-7 Replacing the Print Head
•
Section 9-8 Replacing the Top Half of the Notch/Gap Sensor
•
Section 9-9 Replacing the Paper End Switch and the Bottom
Half of the Notch/Gap and Eye-Mark Sensors
•
Section 9-10 Power Supply Checks
•
Section 9-11 Potentiometer Assignments
•
Section 9-12 Gap/See Through Sensor
•
Section 9-13 Pitch Sensor Adjustment (Eye-Mark Tag/Label)
•
Section 9-14 Ribbon Sensor Adjustment
To Next Page
