PN 9001024
Rev. B Jan. 2000
Page 2-25
SATO CL608 & CL612 SERVICE MANUAL
SECTION 2 – Configuration
2-5 Printing Test Labels
This option allows you to print a test label. It is recommended that you print a test label
after you have changed any of the settings in the Advanced Mode. The test label allows
you to verify that you indeed did make the desired changes. To enter the User Test Print
Mode, power up the printer while pressing the FEED key and an audible signal will be
heard. Release the FEED key and the printer to display the following message on the
LCD panel.
Print Size
STEP PROCEDURE
1. Use the LINE key to step the underline cursor to either the
Large or Small selection.
If Large is underlined, a label will be printed for a maximum
width label (4). Press the FEED key to print the label which
will contain a head check pattern and current printer setting
information. The default position is Large.
To access this setting, perform the following steps:
To Next Page
Loading...
