PN 9001024
Rev. B Jan. 2000
SECTION 2 – Configuration
Page 2-26
SATO CL608 & CL612 SERVICE MANUAL
Print Size (Cont.)
2. If SMALL is underlined, the Print Size message will be displayed. You
must enter the size of the label. The minimum label size that can be
selected is 4 cm (1.6) and the maximum size is 10 cm (3.9). Press
the FEED key and then press the LINE key to increment the setting by
1 cm each time the key is pressed. Once the maximum size is reached,
the display will wrap around and start incrementing at 4 cm again.
Once the correct label width is selected, press the FEED key to initiate
the print.
3. If you wish to pause the printer after it starts to print a test label,
press the FEED key. Press the FEED key again to resume the test
label printing. To stop the test label print, pause the printer and
then turn power off.
STEP PROCEDURE
LARGE LABEL
SMALL LABEL
To Next Page
Loading...
