SATO CL608 - Top Notch;Gap Sensor Replacement (Early Models)

PN 9001024
Rev. B Jan. 2000
Page 9-15
SECTION 9 – Addendum
SATO CL608 & CL612 SERVICE MANUAL
Serial No. 81199999 and below
CL608 & CL612
Serial #8199999 and below
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cable.
2. Remove (3) screws holding the left side cover to the printer. Raise the
access door and loosen the (2) screws on the inside top of the printer.
Lift off the left side cover to expose the main PCB. Refer to Section 4-2.
3. Raise the access door and remove the ribbon and label stock if installed.
Fig. 9-16
4. Refer to Fig. 9-17. In the electronics compartment locate and remove
the screw holding the media hold-down unit (containing the top half of
the Notch/Gap Sensor) to the frame. Detach SEN2 connector from the
sensor to the PCB and withdraw the cable through the frame hole.
Remove the media hold-down unit. Fig. 9-18 & 9-19
5. Remove (2) screws to open the media hold down cover to access the
Notch/Gap Sensor. Fig. 9-20 & 9-21
6. Remove (2) screws to detach the Notch/Gap Sensor from the media hold-
down unit. Install a replacement sensor. Fig. 9-22 & 9-23
7. Attach the media hold-down cover.
8. Reattach the media hold-down unit to the frame. Attach connector to the
PCB.
9. Replace the left side cover and reconnect the power cable.
The media hold down cover contains the top half of the
Notch/Gap Sensor and adjustment screws. It also contains
the pressure roller.
9-8 Replacing the Top Half of the Notch/Gap Sensor
RAISE THE
ACCESS DOOR
Fig. 9-16