SATO CL608 - Replacement Procedures; Replacement Procedures Overview

PN 9001024
Rev. B Sept. 1999
Page 6-1
SATO CL608 & CL612 SERVICE MANUAL
Replacement Procedures
6-1 Overview
SATO CL608/CL612 printers contain replaceable components and sub-assemblies. This
section contains step-by-step instructions for removing and replacing the following
components and sub-assemblies.
•
Main Circuit Board
• Fuses
• Power Supply
• Stepper Motor
• Timing Belts
• Print Head
• Platen
• Ribbon Clutch Washers
• Ribbon Motion Sensor
• Label Sensor
• Top Notch/Gap and "Eye-Mark Sensors
• Display Panel
6
Section