SATO CL608 - Default Printer Settings

PN 9001024
Rev. B Jan. 2000
Page 2-9
SATO CL608 & CL612 SERVICE MANUAL
SECTION 2 – Configuration
2-2 Default Settings
Switch Selections
All switches are placed in the OFF position (default) for shipping. This will result in the
following operating configuration:
Sensor: Gap Sensor
Receive Buffer: Single Job
Mode: Batch/continuous
Label Sensor: Sensor Used
Back feed: Enabled
External Signals: Disabled
Software Default Settings
The CL608/CL612 stores the software settings upon receipt and uses them until they
are again changed by receipt of a command containing a new setting. These settings
are stored in non-volatile RAM and are not affected by powering the printer off. The
printer may be reset to use the default software settings by depressing the LINE and
FEED keys simultaneously while powering the printer on. This will result in the
following default configuration:
User Mode Default Settings
Print Darkness: = #2
Print Speed: = 150 mm/s
Pitch Offset: = 00 mm
Advanced Mode Default Settings
Zero Slash: = YES
Auto Online = YES
Vert. Offset: = 0000
Horiz: = 0000
Input: = 1.5
Calendar Enabled: = NO
Ignore CR/LF: = NO
Print Darkness: = #1
Once the default operation is completed, a DEFAULT SETTING COMPLETED
 message will be displayed on the LCD panel. The printer should be powered off while
this message is being displayed. This saves the default settings in the EEPROM where
they will be automatically loaded the next time the printer is powered on.
DEFAULT SETTING
COMPLETED