SATO CL608 - Notch;Gap Sensor Adjustment

PN 9001024
Rev. B Jan. 2000
Page 5-15
SATO CL608 & CL612 SERVICE MANUAL
SECTION 5 – Mechanical Adjustments
5-10 Notch/Gap Sensor Adjustment
The CL-608/612 printers can position labels using either a label gap (transmissive) or
a Eye-Mark (reflective) sensor. The sensor used is selected by DSW2-2. (page 2-2)
The gap sensor position can be adjusted over a limited range.
LOOSEN ADJUSTMENT
SCREW AND REPOSITION
IN SLOT. TIGHTEN SCREW
LABEL FEED
DIRECTION
INSIDE EDGE
OF PRINTER
1" (25 mm)
Minimum
12345678901234567890123456
1
234567890123456789012345
6
1
234567890123456789012345
6
1
234567890123456789012345
6
1
234567890123456789012345
6
12345678901234567890123456
NOTCH/GAP SENSOR
ADJUSTMENT RANGE
NOTCH/GAP LOCATIONS
(MAXIMUM & MINIMUM)
3.5" (90 mm) Maximum
.33" (9 mm) Eye-Mark
Sensor Location
(shown for ref. only)
EYE - MARK Minimum Size
.12" (3 mm) W x .24" (6 mm) L
LABEL
MINIMUM INTER-LABEL
GAP .012" (3 mm)