SATO CL608 - Page 47

PN 9001024
Rev. B Jan. 2000
SECTION 2 – Configuration
Page 2-24
SATO CL608 & CL612 SERVICE MANUAL
Advance Mode Counters
The Counter Clear display is used to reset the internal printer counters to zero. The
counters allow the user to keep track of the number of centimeters of label material that
has passed through the printer, how many labels have been dispensed, or how many
labels have been cut. The correct counter values can be viewed by printing out a test
label.
The Counters are identified in the display as:
LIFE: Life
HD: Head Counter
DSP: Dispense Counter
CUT: Cutter Counter
To access this setting, perform the following steps:
COUNTERS
HD DSP CUT LIFE
STEP PROCEDURE
1. Use the LINE key to step the underline cursor to the counter to be
reset or displayed; the Head counter (HD), Dispenser (DSP)
counter, CUT (Cutter) counter, or the LIFE counter.
2. Once the correct setting is underlined, press the FEED key to display
selected counter value in meters.
3. Press the FEED key to advance to the Counter Clear display (CNTR
CLEAR). Use the LINE key to underline YES if you want to reset
the counter to 0. Underline NO to keep the current values. Press
FEED to continue the desired operation and advance to the EXIT
ADV Mode display
4. Using the LINE key, underline YES or NO to exit advanced mode
(YES/NO) to return to the Advanced Mode Setup display.