PN 9001024
Rev. B Jan. 2000
Page 2-23
SATO CL608 & CL612 SERVICE MANUAL
SECTION 2 – Configuration
Ignore Carriage Return/Line Feed
Print Darkness Setting
Exit Mode
This setting is an entry provided to ignore a Carriage Return or Line Feed
command in the data stream.
There are two Darkness (or heat range) settings. If you are printing large amounts
of coverage on each label you will want to choose TYPE 2 to prevent head
saturation or excessive heat buildup. The current setting is indicated by a line
under one of the range settings. Refer to Section 4-11 for user mode darkness
settings that work in conjunction with these two broad range settings.
STEP PROCEDURE
1. Use the LINE key to step the underline cursor to the desired setting.
2. Once the desired setting is underlined, press the FEED key to
accept the setting and advance to the next adjustment.
STEP PROCEDURE
1. Use the LINE key to step the underline cursor to either NO or YES.
2. Once the desired setting is underlined, press the FEED key to
advance the display to the offline mode if YES is selected or to
recycle back through the advanced mode in NO is selected.
To access this setting, perform the following steps:
To Next Page
Loading...
