PN 9001024
Rev. B Jan. 2000
SECTION 2 – Configuration
Page 2-22
SATO CL608 & CL612 SERVICE MANUAL
If the Calendar Option is installed in the printer, the date and time can be set
manually using the LCD display or via the <ESC>WT Calendar Set command. The last
setting, set either manually or via software command, received by the printer will be
the value used. The format of the display is YY/MM/DD hh:mm
(Year/Month/Day/hours: minutes). The date format is fixed and cannot be changed.
To access this setting, perform the following steps:
STEP PROCEDURE
1. Year: The first display shown will have the two digit year selection
underlined. Press the LINE key to scroll through the dates. The year number
will increase by one value each time the LINE key is pressed.
2. Month: After you have set the correct year, press the FEED key to advance
the underline cursor to the two digit Month position. Press the LINE key to
scroll through the numbers corresponding to the month. The month number
will increase by one value each time the LINE key is pressed.
3. Day: After you have set the correct month, press the FEED key to advance
the underline cursor to the two digit Day position. Press the LINE key to
scroll through the numbers corresponding to the date. The date number will
increase by one value each time the LINE key is pressed.
4. Hour: After you have set the correct date, press the FEED key to advance
the underline cursor to the two digit Hour position. Press the LINE key to
scroll through the numbers corresponding to the hour (using a 24 hour clock).
The hour number will increase by one value each time the LINE key is
pressed.
5. Minute: After you have set the correct hour, press the FEED key to advance
the underline cursor to the two digit minute position. Press the LINE key to
scroll through the numbers corresponding to the minute. The minute number
will increase by one value each time the LINE key is pressed.
6. After you have set the calendar, press the FEED key to accept the setting and
advance to the next display.
Calendar Set
To Next Page
Loading...
