SATO CL608 - Page 61

PN 9001024
Rev. B Jan. 2000
Page 3-12
SATO CL608 & CL612 SERVICE MANUAL
SECTION 3 – Interface Specifications
3-5 Dip Switch Settings for RS232 Serial Interface
RS232 Transmit/Receive Setting
(Located on RS232S Serial Interface Card)
DSW1
ON
OFF
1 2 3 4
5 6 7 8
DSW1-1 SETTING
Off 8 data bits
On 7 data bits
Data Bit Selection (DSW1-1): This switch set the printer to receive either 7 or
8 bit data bits for each byte transmitted.
DSW1-2 DSW1-3 SETTING
Off Off No Parity
Off On Even
On Off Odd
On On Not Used
Parity Selection (DSW1-2 and DSW1-3): These switches select the type of
parity used for error correction.
DSW1
ON
OFF
1 2 3 4
5 6 7 8
RS232 Transmit/Receive Setting
DSW1
ON
OFF
1 2 3 4
5 6 7 8
DSW1-4 SETTING
Off 1 Stop Bit
On 2 Stop Bits
Stop Bit Selection (DSW1-4): Selects the number of stop bits to end each byte
transmission.