SATO CL608 - RS232 Dip Switch Settings

PN 9001024
Rev. B Jan. 2000
Page 3-11
SATO CL608 & CL612 SERVICE MANUAL
SECTION 3 – Interface Specifications
IICSAXEHNOITINIFED
NOITIDNOCRORRE,ENIL-FFO
a16lluFreffuBevieceR
b26nepOdaeH
c36dnErepaP
d46dnEnobbiR
e56rorrEaideM
f66rorrErosneS
g76rorrEdaeH
i86rorrEdraCyromeM
jA6rettuC
kB6noitidnoCrorrErehtO
3-4 RS232C Serial Interface (Cont.)
Status Byte Definition, Bi-Directional Protocol
3-5 Dip Switch Settings for RS232 Serial Interface
DSW1 DIP Switch is located on the RS232 Serial Interface Card and is used to set
transmit/receive parameters. This card is installed by inserting it through the slot in
the back of the printer directly to the main PCB board. The switches can be set by
either removing the card or by opening the left side panel.
DSW1