SATO CL608 - Page 118

PN 9001024
Rev. B Jan. 2000
Page 6-21
SATO CL608 & CL612 SERVICE MANUAL
SECTION 6 – Replacement Procedures
Fig. 6-43
6-8 Replacing the Platen
Fig. 6-41
PULL PLATEN
THROUGH HOLE IN
FRAME AND OUT THE
ELECTRONICS
COMPARTMENT
Fig. 6-40
DISPLACE PLATEN BY
PULLING UP AND
AWAY FROM HOLDING
CLAMP
Fig. 6-42
HOLDING CLAMP
WITH HEAD RELEASE
LEVER IN PLACE
HOLDING CLAMP
WITH HEAD RELEASE
LEVER REMOVED
FOR CLARITY AND
SHOWING THE
SPRING IN CORRECT
POSITION
BUSHING PLATE
SPRING END MUST
NOT BE UNDER
BUSHING PLATE