SATO CL608 - Paper End Switch and Sensor Replacement

PN 9001024
Rev. B Jan. 2000
Page 6-29
SATO CL608 & CL612 SERVICE MANUAL
SECTION 6 – Replacement Procedures
MEDIA HOLD DOWN COVER
(SHOWN IN RAISED POSITION)
CONTAINS THE TOP HALF OF
THE NOTCH/GAP SENSOR
NOTCH/GAP SENSOR
(TOP HALF)
NOTCH/GAP SENSOR
(BOTTOM HALF)
PAPER END SWITCH
(MICRO-SWITCH)
EYE-MARK
SENSOR
SENSOR LOCATIONS
Fig. 6-61
Fig. 6-60
RAISE THE
MAIN COVER
6-11 Replacing the Paper End Switch (Micro-Switch) and the
Bottom Half of the Notch/Gap and Eye-Mark Sensors