SATO CL608 - Display Panel or Keypad Replacement

PN 9001024
Rev. B Jan. 2000
Page 6-37
SATO CL608 & CL612 SERVICE MANUAL
SECTION 6 – Replacement Procedures
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cable.
2. Remove (3) screws holding the left side cover to the printer. Raise the
access door and loosen the (2) screws on the inside top of the printer.
Lift off the left side cover to expose the main PCB. Refer to Section 4-2.
3. Raise the mechanical section lid. Remove (1) screw from the cover that is
attached to the frame. The location is where the platen goes through the
casting. Fig. 6-83 & 6-84
4. Remove (2) screws from cover. Fig. 6-85
5. In the electronics compartment, detach cable marked KB from the
Display Panel back.
6. Remove (2) screws from the back plate that is secured to the cover and
the Display Panel Assembly. Fig. 6-86 Rotate forward and lift to detach
the cover. Fig. 6-87
7. In the mechanical section, remove (1) screw that attaches the Display
Panel Assembly to the frame. Fig. 6-88
8. Remove (2) screws from the bottom of the Display Panel Assembly.
Fig. 6-89
9. Lift to remove the Display Panel Assembly. Fig. 6-90
10. Install a replacement display panel or keypad.
11. Reinstall Display Panel Assembly using screws previously removed.
12. Reconnect KB cable to the display after reinstalling assembly.
13. Reinstall Cover.
14. Replace the left side cover and reconnect the power cable.
DISPLAY
PANEL
COVER
MECHANICAL
SECTION LID
Fig. 6-83
6-13 Replacing the Display Panel or Keypad