PN 9001024
Rev. B Jan. 2000
Page 1-11
SATO CL608 & CL612 SERVICE MANUAL
SECTION 1 – Overview & Specifications
1-7 Operator Panel/Displays
VR1-PRINT POTENTIOMETER:
To adjust print darkness (fine
adjustment).
VR3-PITCH POTENTIOMETER:
To adjust home print position of
the label (+/- 3.75 mm).
VR4-DISPLAY POTENTIOMETER:
To adjust the contrast of the LCD
display.
VR2-OFFSET POTENTIOMETER:
To adjust amount of back/forward
feed for dispenser/cutter/tear-off
bar position (+/- 3.75).
DSW 1, 2 & 3: Dip switches used
to set operational parameters of
printer. Refer to Section 2 for
settings. NOTE: DSW 1 is
reserved. To set DSW1 on the
interface board, see Section 3.
COVER
To Next Page
Loading...
