SATO CL608 - Page 163

PN 9001024
Rev. B Jan. 2000
Page 9-11
SECTION 9 – Addendum
SATO CL608 & CL612 SERVICE MANUAL
Serial No. 81199999 and below
9-6 Installing the Memory Board
CL608 & CL612
Serial #8199999 and below
Fig. 9-8
Fig. 9-9
CONNECTOR ON
MAIN CIRCUIT BOARD
CONNECTOR ON
MEMORY BOARD
MATCH INDEXING
MARKS
Error Handling:
The Memory Card Option provides the connectors and interface board for two
PCMCIA memory card slots, Slot A and Slot B. The memory card slots are
accessible from the back panel. The printer memory can be expanded to 4MB.
The maximum per slot is 2MB.
ATTACH (4)
STANDOFFS
MEMORY BOARD
SHOWN INSTALLED
Error Description
LOW BATTERY
Low battery condition is detected
when printer is powered on.
CARD R/W ERROR
1. No card is inserted.
2. Card is write protected.
3. Invalid store/recall number.
4. Card has not been initialized.
WARNING
1. Duplicate number.
2. Data not in print area.
3. Data overflows card memory.
Indication
STATUS LED - Red Blinking
Audible Beep - 1 long
Display - Card low battery
Depress LINE key to print card
status
STATUS LED - Red
Audible Beep - 1 long
Display - Card R/W error
Printer must be powered off to
reset.
Audible Beep - 1 short
Display - None
Printer will ignore invalid
commands.
Remedy
Replace Memory Card
Battery. Note that all
data will be lost when
the battery is removed.
1. Insert card into
selected slot
2. Remove write
protect tab.
3. Correct program.
4. Initialize card with
BJF command.
1. Correct program.
2. Correct program
3. Use card with more
capacity.