PN 9001024
Rev. B Jan. 2000
SECTION 2 – Configuration
Page 2-12
SATO CL608 & CL612 SERVICE MANUAL
Print Speed Adjustment
There are 3 SPEED settings on the CL608/CL612 printer. Each setting is listed on the bottom line of
the display. The current setting is indicated by a line under one of the speed settings.
To change the setting perform the following steps:
STEP PROCEDURE
1. Use the LINE key to step the underlined cursor to the desired setting.
2. Once the correct setting is underlined, press the FEED key to accept the
setting and advance to the next adjustment (Pitch Offset).
Note: This setting can be overridden by software.
Pitch Offset and Direction
The label pitch is the distance from the leading edge, (the edge that comes out of the
printer first) of a label and the leading edge of the printing. The leading edge
position of the label can be adjusted relative to the print head +/- 49 mm in
increments of 1 mm using the following procedure. Once the position is set, it can be
adjusted +/- 3.75 mm using the PITCH potentiometer on the adjustment panel.
LINE FEED
DIRECTION
MOVED WITH MINUS
(-) OFFSET
ORIGINAL PRINT LINE
MOVED WITH POSITIVE
(+) OFFSET
PRINT SPEED
4
68
To Next Page
Loading...
