SATO CL608 - Page 5

iii
PN 9001024
Rev. B Jan. 2000
SATO CL608 & CL612 SERVICE MANUAL
Contents
Page
Section 9. ADDENDUM
Replacing the Fuses .................................................................................... 9-6
Replacing the Power Supply ....................................................................... 9-8
Installing the Memory Board....................................................................... 9-10
Replacing the Print Head............................................................................. 9-12
Replacing the Top Half of the Notch/Gap Sensor ...................................... 9-15
Replacing the Paper End Switch and the
Bottom Half of the Notch/Gap and Eye-Mark Sensors.............................. 9-18
Power Supply Checks ................................................................................. 9-22
Potentiometer Assignments ....................................................................... 9-24
Gap/See-Through Sensor ........................................................................... 9-25
Pitch Sensor Adjustment (Eye-Mark Tag/Label) ....................................... 9-27
Ribbon Sensor Adjustment ........................................................................ 9-29