SATO CL608 - Page 8

PN 9001024
Rev. B Jan. 2000
Page 1-3
SATO CL608 & CL612 SERVICE MANUAL
SECTION 1 – Overview & Specifications
1-2 Physical Characteristics
RIBBON SUPPLY
SPINDLE
ACCESS DOOR
RIBBON REWIND
SPINDLE
MEDIA HOLDER
PLATEN
ROLLER
MEDIA KNOB
LABEL SUPPLY
GUIDE
HEAD LATCH
PRINT HEAD
ASSEMBLY
SWITCHES AND SENSORS
Refer to Section 1.6
LABEL TEAR
OFF PLATE
Adjust the Media Knob based on the
media you have loaded. For media up to
2.3 inches wide, use the "1" position. For
media between 2.3 and 4.6 inches wide,
use the "2" position. For media wider than
4.6 inches wide, use the "3" position. If
you use media narrower than 7 inches,
using the wrong setting can void the print
head warranty due to excessive pressure.
MEDIA HOLD
DOWN