Scaime IPE100 - IPE100 Scale Zero and Tare Functions; IPE100 Scale Zero Function; IPE100 Tare Functions Overview; Semi-Automatic Tare Operation on IPE100

IPE100 indicator NU-IPE100-IO-USER-E-0212
21
6. SCALE ZERO FUNCTION
With various connected scales, select the scale using the numerical keyboard, using the 2ndF and the 0, 1, 2 and 3 keys.
Keep the ZERO key pressed; the message "Zero" appears on the display after which:
- If the weight on the scale is included in the percentage of capacity configured in the << 0.PErC >> (RIF.MAN.T.) step, it
is zeroed;
- If the weight is not within this range, it will not be cleared and an error sound is emitted.
In the end the indicator automatically returns to the display of the weight present on the scale.
6.1 CYCLICAL AUTOMATIC ZERO
If the cyclical automatic zero has been set at the start-up (in the SEtuP >> ConFig >> ParaM >> Auto 0 step of the setup,
TECHNICAL MANUAL.), by pressing the combination of the 2ndF and ZERO keys, a zero cycle is executed in all the
current scales.
7. TARE FUNCTIONS
7.1 SEMIAUTOMATIC TARE
By pressing the TARE key one tares any weight which is on the scale; the display shows “tArE” for an instant and then 0
(net weight); the NET and T, or , indicators turn on; the LCD display shows furthermore the stored tare value.
Whatever the case, a new operation automatically cancels and substitutes the previous one.
NOTES:
- The automatic tare is acquired only if the weight is of AT LEAST ONE DIVISION AND IS STABLE (~ instability led
indicator is off) and LOWER THAN THE MAXIMUM CAPACITY.
- In the “vehicle with trailer” and in the “A+B” functioning modes, the semiautomatic tare is inhibited.
7.2 PRESET TARE
To enter the tare value, one can do it in several ways:
1) With the numeric keyboard type the value (including the decimal point) and press TARE.
The C key quickly zeros the current value.
2) Select a vehicle in database linked to a tare different than 0.
The indicator automatically subtracts the entered value from the displayed weight, (the NET and T, or , indicators
turn on), as long as it is not greater than the instrument’s maximum capacity.
The LCD display shows furthermore the stored tare value, identified with “PT” (Preset Tare).
NOTES
- In the printout, the manual tare is identified with “PT” (Preset Tare).
- In the “vehicle with trailer” and in the “A+B” functioning modes, the display in any case shows the gross weight also in
the presence of a manual tare.
7.3 MANUAL CALCULATED TARE
With the “CALCULATOR” function it is possible to add or to subtract to the current tare the result of the operation between
two values enterable with the keyboard.
For the functioning specifications see the 15.1 CALCULATOR section.
7.4 TARE CANCELLATION
To cancel the stored tare:
- With an unloaded platform, press the TARE key.
- With loaded platform press in sequence the numeric 0 key and TARE.