Scaime IPE100 - Messages and Errors During Weighing

IPE100 indicator NU-IPE100-IO-USER-E-0212
53
17.2 IN WEIGHING
MESSAGE DESCRIPTION
WEIGHT UNDER
20 DIVISIONS
It is shown in the LCD display when one tries to print or totalise with the 0 or negative weight.
NO ZERO CROSS OR
INSTABILITY
Printing or totalisation not possible without having the weight pass by the net zero or by
instability.
*** POWER OFF *** Turning off of the instrument through the key (see section 3.3).
“- OUT CAPACITY ! –“
OVERLOAD
The weight is 9 divisions above the Maximum Capacity.
OR
UNDERLOAD
- Approved instrument:
The weight is under the gross zero (-100 divisions).
- Non approved instrument:
The weight is under the gross zero (- capacity – 9 divisions).
ZERO Execution of scale zero (see section 6).
TARE Tare execution (see section 7).
CLEAR Tare cancellation (see section 7.4)
prn-on Turning on printer for maintenance (see section 3.5).
GROSS Visualisation of the gross weight.
NET Visualisation of the net weight.
LOCK Tare lock or enabled keyboard function.
UNLOCK Tare lock or disabled keyboard function.
Low.Batt Indicates that the battery is discharged (voltage at minimum level).
PRINTER ERROR:
CHECK THE CTS!
Error during the printing: totalisation not possible or printing not executed / finished.
USER - PRESS KEY See section 12.
ERROR SX
CELL Y
It is shown when there is an error in the communication with the X scale – Y cell : check the
connections and communication parameters for digital load cells (TECHNICAL MANUAL.).