Scaime IPE100 - Weighing Through Vehicle License Plate; Input Weighing Using License Plates

IPE100 indicator NU-IPE100-IO-USER-E-0212
36
Confirm with ENTER or press another key to cancel.
• If no input weigh has been made, if one then enters the menu of the “open” weighs, the indicator will show on the
LCD display “NO OPEN WEIGHS IN INPUT” and will emit a prolonged sound; then it will cancel the weigh and return
to weighing.
13.3 WEIGHING THROUGH VEHICLE LICENSE PLATE
NOTE: the functioning mode must be enabled: set F.ModE >> totAL >> WEi.MEM step of the SETUP environment on
“PLAtE” (TECHNICAL MANUAL.).
In this functioning mode, the indicator links the selected plate (through the vehicle) to the input weigh.
13.3.1 INPUT WEIGH
13.3.1.1 SINGLE VEHICLE
(F.ModE >> totAL >> WEi.Mod step of the setup set on “nor.WGt”,TECHNICAL MANUAL.)
The procedure is the same as the weighing through ID code (see section 13.2.1.1).
13.3.1.2 VEHICLE WITH TRAILER
(F.ModE >> totAL >> WEi.Mod step of the setup set on“SEC.WGt”, TECHNICAL MANUAL.)
The procedure is the same as the weighing through ID code (see section 13.2.1.2).
NOTES ON INPUT WEIGHING
• One must select a vehicle, otherwise the indicator will show on the LCD display “PLATE NOT PRESENT” and will
emit a prolonged sound; and then it cancels the weigh and returns to weighing.
• If there is a tare, a SINGLE WEIGH is executed.
• If one executes 999 weighs without executing any output weigh, when one executes the following input weigh, the
indicator will display the message “WEIGHS MEMORY EMPTY”; one should execute at least one output weigh in
order to free up the memory storage to be used.
To cancel all the memory storages, go to the Prn.ViS >>> 0.W.List step in the menu of the ENTER key.
If one needs to make a simple weigh without any input/output and databases, it is advisable to use the print
key, in order to not occupy the memory storages.
• If one executes the input weigh with a selected vehicle, one should execute the output weigh, in order to reuse the
same vehicle in a new weigh (the LCD display shows “PLATE ALREADY PRESENT!”).
13.3.2 OUTPUT WEIGHING
13.3.2.1 SINGLE VEHICLE
(F.ModE >> totAL >> WEi.Mod step of the setup set on “nor.WGt”, TECHNICAL MANUAL.)
- Position the vehicle on the scale.
- Select, if requested, the customer / material to be linked to the weigh.
- Now it’s possible to proceed in two ways:
Press F7, the LCD display will show:
INSERT
PLATE
_