IPE100 indicator NU-IPE100-IO-USER-E-0212
40
NOTE: The number of settable digits DOES NOT INCLUDE the comma.
13.9.2 TICKET PROGRESSIVE
Through function 402, combinable with the desired key (<< F.KEYS >> step, TECHNICAL MANUAL.), it’s possible to
modify or clear the TICKET PROGRESSIVE (up to 5 digits).
The TICKET PROGRESSIVE is a progressive number which increments of one UPON THE FIRST TOTALISATION
SUBSEQUENT TO THE CLEARING OF THE PARTIAL TOTAL.
13.9.3 LOT PROGRESSIVE
Through function 403, combinable with the desired key (<< F.KEYS >> step, TECHNICAL MANUAL.), one obtains the
clearing of the AUTOMATIC LOT (up to 6 digits); before carrying out the actual clearing, one is asked to confirm or cancel
the operation; confirm with ENTER.
The AUTOMATIC LOT is a progressive number which increments of one UPON THE FIRST TOTALISATION
SUBSEQUENT TO THE CLEARING OF THE GENERAL TOTAL..
14. PRINTOUTS
The instrument is fitted with 12 different print functions, which may be used while weighing, and of 30 print formats, in other
words, 30 different memory storages, each of which contain a programmable printout.
The printouts executed by 12 of these functions depends on the print format linked to it; see the following section for the
linkages.
The format linking function allows executing various printouts, by changing the linked format each time.
The available functions are:
SIMPLE PRINTOUT - Programmable printout -
Through the F5 key one prints the linked format, without executing the input/output weigh or single weigh.
With the APPROVED instrument:
- The printing works if there is a NET WEIGHT of at least 20 divisions.
- The printout is reenabled depending on how the F.ModE >> rEACt parameter has been programmed in the
TECHNICAL SETUP (TECHNICAL MANUAL.).
- The simple print function excludes the totalisation and vice versa.
With the NON APPROVED instrument:
- The printing works if there is a NET WEIGHT greater than zero.
- The simple printout does not exclude the totalisation and is always active (the programming of the F.ModE >> rEACt
parameter of the TECHNICAL SETUP TECHNICAL MANUAL. is not taken into consideration).
INPUT WEIGH - Programmable printout -
With the F6 key one prints the data relative to the INPUT WEIGH (format linked to the S.F.06 function), or to the SINGLE
WEIGH (format linked to the S.F.05 function) in case the known tare has been entered.
For the totalisation conditions, see section 13.4.
OUTPUT WEIGH - Programmable printout -
With the F7 key one prints the data relative to the OUTPUT WEIGH (format linked to the S.F.07 function) or to the SINGLE
WEIGH (format linked to the S.F.05 function) in the case that the known tare has been entered.
For the totalisation conditions, see section 13.4.
To Next Page
Loading...
