IPE100 indicator NU-IPE100-IO-USER-E-0212
39
13.7 REENABLING THE PRINTING AND INPUT / OUTPUT WEIGH
After having carried out an input/output weigh or a single weigh, in order to carry out a new one, the displayed weight must
pass by the zero or become unstable.
This setting is made in the SETUP environment, in the F.ModE >> rEACt. parameter (TECHNICAL MANUAL.).
While using the indicator, one may incur in the “WEIGHT NOT PASSED BY 0 OR UNSTAB.” error shown on the LCD
display, this means that the function which one wants to carry out, must be reenabled (in order to avoid accidental
executions).
In any case, one can also exclude this type of check: in order to do this, one should set “ALWAYS” in the F.ModE >> totAL
>> t.ModE step (TECHNICAL MANUAL.)
13.8 VISUALISATION AND CLEARING OF THE ACCUMULATED TOTALS
Each total can be momentarily viewed on the display or cleared independently through the printout, linking the
corresponding function to the desired key (<< F.KEYS >> step, TECHNICAL MANUAL.):
TOTAL FUNCTION CODE FOR
VISUALISATION
FUNCTION CODE FOR
RESETTING
PARTIAL TOTAL 416 418
GENERAL TOTAL 419 421
GRAND TOTAL 422 424
CUSTOMER TOTAL 404 406
MATERIAL TOTAL 408 410
VEHICLE TOTAL 412 414
ALL CUSTOMERS TOTAL - 407
ALL MATERIALS TOTAL - 411
ALL VEHICLES TOTAL - 415
ALL SCALE TOTAL
(partial total, general total, grand total)
- 425
LIST SAMPLES - 426
By recalling one of the clearing functions, the instrument requests a confirmation before proceeding with the cancellation:
press ENTER to clear, C for continuing to accumulate.
It’s possible to disable the confirmation request, in the F.ModE >> totAL >> rESEt step, TECHNICAL MANUAL.
In case of visualisation of the total, the instrument automatically exits the function after a few seconds.
NOTES:
- The weight data of the cleared total will be updated only with the subsequent input/output weigh or single weigh.
- The ARTICLE TOTAL is article specific, in other words, there is a total for EACH ARTICLE USED.
The other totals are GENERIC, and can be cleared INDEPENDENTLY ONE FROM THE OTHER (i.e. if one clears the
Grand total, with the following input/output weigh, the other totals will continue to increment, while the Grand total will
restart from 0).
- By clearing the weighs’ list one obtains the clearing of all the “open” input weighs: By carrying out this operation all the
weighing operations under way are cancelled.
13.9 PROGRESSIVES
13.9.1 PROGRESSIVE DIGITS
Through function 401, combinable with the desired key (<< F.KEYS >> step, TECHNICAL MANUAL.), it’s possible to set
the number of digits with which the TICKET PROGRESSIVE and LOT PROGRESSIVE are printed.
The number of settable digits varies from 4 to 16, organised in this way:
- if the actual digits of the total are less than the number of digits set in this step, the difference is filled with some
spaces.
- if the actual digits are greater than the number of digits set in this step, only the ones actually entered are taken into
consideration (counting from right to left).
The alignment of the total fields is on the left.
To Next Page
Loading...
