Block H : Zero setting
H 09 ZDO active
Range: NO
YES
Original value: NO
Activating zero drop out equipment (refer to H 10).
H 10 ZDO limit
Range: 0.0-10.00% Q Orginal value: 1.00% Fo
Reference: Nominal belt load D 01
The measurement of flow rate and totalized amount of material is suppressed if this is below
the belt load and limit set when the ZDO equipment is activated.
No feature appears on the display.
48 BV-H2346GB / 0833 Operating Manual INTECONT® Satus
© Schenck Process
To Next Page
