The PDU must be installed in a restricted access location
Socket-outlet must be installed near the equipment
Socket-outlet must be easily accessible
Installation by expert personnel only
After installation: default passwords / RC4 keys MUST be changed (see: Part III - Administrator manual)
SAFETY WARNINGS
This manual contains important safety instructions that should be followed during installation and operation of the PDU.
Please read this manual carefully since there may be serious or fatal personal injury and damage to the equipment if the
safety instructions, warnings and directions are not followed. Please save this document for future use.
EXPERT PERSONNEL
Installation, maintenance and inspection of the Schleifenbauer Intelligent PDU must be carried out by adequately trained
persons according to NEN EN 50110-1, with full observance of the specifications of NEN EN 50110-1 and NEN 3140.
TECHNICAL INSTALLATION REQUIREMENTS
Before installing and putting the system into operation, check whether the characteristics of the electrical system to which
connection is to be made correspond to the product specifications.
● The Schleifenbauer Intelligent PDU has been designed for connection to electrical systems that comply with IEC
60364 or in the Netherlands, NEN 1010.
● The voltage, maximum permitted current and the number of phases must be correct. This information is
displayed on the front side of the PDU.
● The maximum permitted power must be taken into account with regard to the maximum length and the diameter
of the connecting lead.
● The values and characteristics of the in-series protective devices must match the PDU and the protective
elements included in it.
● The environmental factors must correspond to the product specifications.
VISUAL INSPECTION
After opening the cardboard box and removing the packaging material, the PDU should be checked visually. The PDU
should not be put into operation if damage is detected such that safe and proper operation cannot be guaranteed. In such
cases, please contact Schleifenbauer Products BV.
Note that, in the case of PDUs that are equipped with an over voltage protection, the overvoltage protection and the
respective overcurrent protection (if applicable) must be inspected on a regular basis.
To Next Page
Loading...