OPERATING MODES
2. Press SET to enter the function.
The multifunction gauge message
will change to RAMP. The RAMP
setting number will be visible in the
numerical display.
sdd2009-001-024_f
1. SET button
1
smo2010-002-117_a
FIRST SETTING AVAILABLE - RAMP
1. RAMP setting
3. To change the RAMP setting, press
the UP or DOWN arrow button until
the desired ramp mode number is
visible in the numerical display.
4. Press SET to lock in the ramp set-
ting, the multifunction display will
change to the TARGET SPEED set-
ting function.
1
smo2010-002-118
SECOND SETTING AVAILABLE - TARGET
SPEED
1. TARGET SPEED setting
5. Press the UP or DOWN arrow but-
ton to increase or decrease the tar-
get speed.
6. Press SET to lock in the target
speed, the display will switch to
the following scrolling message SKI
MODE - PRESS_SET_TO START
OR MODE TO EXIT.
smo2010-002-119
SCROLLING MESSAGE - SKI
MODE_PRESS_SET_TO START OR
MODE TO EXIT
NOTE: A BEEP will be heard every 5
seconds as a SKI MODE engaged re-
minder.
7. Press SET again, the following con-
firmation message will appear SKI
MODE ACTIVE - RETURN TO IDLE
TO CANCEL.
114
______________
To Next Page
Loading...
Need help?
General