OPERATING MODES
Learning Key and Rental
Key Modes
There are 5 speed settings available for
each learning and rental modes.
By default, the speed setting is no 5
(highest).
Changing Learning or Rental Key
Speed Settings
NOTE: Changing key settings is only
available when the engine is not run-
ning.
To change learning or rental key set-
tings, carry out the following:
1. Press the START/STOP button to
wake up the electrical system and
install the NORMAL key on the en-
gine cut-off switch.
2. Wait for the information center to
complete its self-test and display
the key recognition message.
3. Press the MODE button repeatedly
until KEY MODE is visible in the digi-
tal screen of the information center.
sdd2009-001-024_b
TYPICAL - GAUGE CONTROL BUTTONS
1. MODE button
2. SET button
3. UPDOWN arrow button
smo2009-002-114_b
FUNCTION SELECTED - KEY MODE
4. Press the SET button once to enable
learning key mode setting function.
The display will change to L-Key.
smo2009-002-114_c
TYPICAL - LEARNING KEY SET TO 1
NOTE: Pressing the SET button twice
will enable the Rental key setting func-
tion. The display will change to R-Key.
smo2009-002-114_cc
TYPICAL - RENTAL KEY SET TO 5
116
______________
To Next Page
Loading...
