CONTROLS
NOTE: The neutral position can be fine
tuned by trimming the iBR system.
Refer to
OPERATING INSTRUCTIONS
for detailed instructions.
4) Engine Cut-Off Switch
To allow engine starting, the tether
cord cap must be securely snapped to
theenginecut-offswitch.
WARNING
Always attach the tether cord clip
to the operator's personal flotation
device (PFD).
sdd2009-001-019_a
TYPICAL
1. Engine cut-off switch
2. START/STOP button
smo2009-002-115_a
TYPICAL
1. Tether cord cap on the engine cut-off switch
2. Tether cord secured to operator's PFD
To stop engine, pull the tether cord cap
from the engine cut-off switch.
WARNING
Should the engine be stopped, the
brake function and all watercraft
directional control is lost.
WARNING
Always disconnect tether cord
when watercraft is not in opera-
tion in order to prevent accidental
engine starting or to avoid unau-
thorized use by others, children,
and to prevent theft.
Digitally Encoded Security System
(D.E.S.S.)
The tether cord cap contains an elec-
tronic circuit (D.E.S.S.
TM
key) that is
programmedtogiveitauniqueelec-
tronic serial number. This is the equiv-
alent of a conventional key.
The D.E.S.S. system reads the key in-
stalledonthe enginecut-offswitch and
only allows engine starting for keys it
recognizes.
The D.E.S.S. system brings great flex-
ibility. You can buy additional tether
cords and have the D.E.S.S. keys pro-
grammed for your watercraft.
A total of ten D.E.S.S. keys can be pro-
grammed.
To have a key programmed to your
watercraft, see your authorized BRP
Sea-Doo dealer.
D.E.S.S. Key Recognition
Two short beeps indicate the system
is ready to allow engine starting. Oth-
erwise, refer to the
TROUBLESHOOT-
ING
section.
D.E.S.S. Key Types
Three types of keys can be used:
–Normalkey
– Learning key
– Rental key (sold separately).
To ease key recognition, the tether
cord float comes in different colors
.
50
______________
To Next Page
Loading...
Need help?
General