OPERATING MODES
NOTE: If the throttle lever is not fully
released when the cruise button is
pressed to deactivate cruise mode, the
BEEP will not be heard and the cruise
light will remain on. The speed limiting
function of cruise mode will stay active
until the throttle is fully released, then
the BEEP will be heard and the cruise
light will go out.
Slow Speed Mode
All Models Except RXT-X and
RXT-X aS
The Intelligent Throttle Control also
allows for a Slow Speed Mode where
the driver can adjustandset idlespeed.
This is usefull when operating in slow
speed zones where the driver must be
especially attentive to possible obsta-
cle avoidance.
The operator can set idle speed
between 1.6 km/h to 11 km/h
(1 MPH to 7 MPH).
If you accelerate above approximately
14 km/h (9 MPH) , Slow Speed Mode
will be deactivated and the engine will
return to idle RPM when the throttle is
released.
Should a situation arise where the op-
erator must stop or accelerate quickly
away from a hazardous situation,
pulling in the iBR lever, or pulling in on
the throttle lever will deactivate slow
speed mode and normal control of the
watercraft will be returned to the oper-
ator.
Activating Slow Speed Mode
To activate slow speed mode of opera-
tion:
1. Release the throttle lever to idle
RPM.
2. Pull in and release the iBR lever to
engage neutral.
3. Press and hold the cruise button for
approximately 1 second.
sdd2009-001-024_g
TYPICAL
1. CRUISE button
All Models Except GTX 155
The green CRUISE indicator light will
come on in the speedometer or mul-
tifunction display to indicate cruise
activation.
sdd2009-001-034_a
CRUISE MODE INDICATOR LIGHT
A message will scroll in the multifunc-
tion display to specify that you are now
in slow speed mode.
MULTIFUNCTION DISPLAY
MESSAGE
SLOW SPEED MODE _ SPEED
ADJUSTING
The default slow speed setting of 1 will
also come on for a few seconds in the
numerical display.
______________
111
To Next Page
Loading...
Need help?
General