MONITORING SYSTEM
Beeper Code Information
BEEPER CODES DESCRIPTION
Bad D.E.S.S. system connection.
Reinstall tether cord cap correctly on the engine cut-off
switch.
Wrong D.E.S.S. key.
Use a tether cord that has been programmed for the
watercraft.
Defective D.E.S.S. key.
Use another tether cord with programmed D.E.S.S. key.
Dried salt water in tether cord cap.
Clean tether cord cap to remove salt water.
Defective engine cut-off switch.
Refer to an authorized Sea-Doo dealer.
1 long beep
(while installing tether
cord on watercraft engine
cut-off switch)
Improper operation of ECM or defective wiring
harness.
Refer to an authorized Sea-Doo dealer.
Watercraft is upside down.
Turn watercraft upright. Refer to
SPECIAL PROCEDURES
.
A 2 seconds beep
every 15 minutes interval
Engine management system fault.
Refer to an authorized Sea-Doo dealer.
Low fuel level.
Refill fuel tank. If problem persists, refer to an authorized
Sea-Doo dealer.
A 2 seconds beep
every 5 minutes interval
Fuel tank level sensor or circuit malfunction.
Refer to an authorized Sea-Doo dealer.
High engine temperature coolant.
See
ENGINE OVERHEATING
.
High exhaust temperature.
Refer to an authorized Sea-Doo dealer.
Continuously beeps
Low oil pressure.
Turn off engine as soon as possible. Check oil level and
refill. Refer to an authorized Sea-Doo dealer.
NOTICE
If the monitoring beeper continuously sounds, stop engine as
soon as possible.
______________
163
To Next Page
Loading...
Need help?
General